Chapter VII · §§150–170
Additional theorems in the differential and integral calculus
Taylor's theorem with its remainder, and its uses for maxima and minima, indeterminate forms and the contact of curves; derivatives of functions of two variables and the total differential; then the definite integral defined as a limit of sums, its properties, and approximate integration.
What you will be able to do
- state Taylor's theorem with Lagrange's remainder, prove it from Rolle's theorem, and bound the remainder
- decide when a Taylor series represents its function, and expand sin, cos and the binomial
- use the first non-vanishing derivative to classify stationary points and to evaluate limits of the form 0/0
- measure the contact of two curves and find the circle of curvature
- compute partial derivatives, apply the chain rule for f(x(t), y(t)), and use the total differential
- define the definite integral through upper and lower sums
- approximate integrals by the trapezium and Simpson's rules, and compare their errors
- prove Taylor's theorem with the integral form of the remainder, and use Cauchy's form to prove the binomial series for −1 < x < 1
Start with “Taylor's theorem: the higher mean value theorems” →
What this chapter adds
Chapter VI built the calculus of one variable: derivatives, the mean value theorem, and integration as the reverse of differentiation. Chapter VII returns to that material and pushes it further in two independent directions.
The first half asks how well a function is described by its derivatives at one point. The mean value theorem compares with using one derivative; Taylor’s theorem uses of them, and says exactly how large the error can be. From that single theorem come power series for , and , a complete test for maxima and minima, a reliable way to evaluate limits of the form , and a measure of how closely two curves touch. The same half then takes the first steps with functions of two variables: partial derivatives, the chain rule along a curve, and the total differential.
The second half rebuilds the integral. In Chapter VI an integral was an antiderivative, and area was taken on trust. Here the definite integral is defined as the common limit of upper and lower sums, area is defined through it, and the familiar rules (integration by parts, substitution, a second proof of Taylor’s theorem) are proved again on this firmer footing. The chapter ends with practical approximation by Simpson’s rule and with integrals of complex-valued functions.
The chapter in five stages
- Taylor’s theorem (§§150–152). Higher mean value theorems; Lagrange’s form of the remainder; the weaker “little-” form that needs only derivatives at one point; and Taylor’s series, with the warning that infinitely many derivatives are not enough for the series to represent the function.
- Three applications (§§153–155). The first non-vanishing derivative decides maxima and minima; limits of the form are found by comparing expansions; and the order of contact of two curves leads to inflexions and the circle of curvature.
- Functions of two variables (§§156–160). Partial derivatives as ordinary derivatives of slices; the chain rule for and why it needs continuous partial derivatives; the mean value theorem in two variables; differentials and the tangent plane.
- The definite integral (§§161–166). Area and the integral as a limit of sums; the measure of an angle and the circular functions placed on a sound basis; direct evaluation of integrals from the definition; general properties; integration by parts and by substitution.
- Remainders and approximations (§§167–170). Taylor’s theorem again, by integration by parts, with Cauchy’s form of the remainder, which finally proves the binomial series for ; approximate integration and Simpson’s rule; integrals of complex functions of a real variable.
How to work through it
- Stage 1 is the core of the first half. Make sure you can prove Taylor’s theorem from Rolle’s theorem yourself: the trick (an auxiliary function that vanishes at both ends) is the same one used for the mean value theorem in §126.
- Keep the two remainders apart. Lagrange’s form gives a bound on the error at a fixed distance ; the form of §151 only says the error is small compared with as . Stages 2 and 3 use the second; Taylor series need the first.
- Stage 3 is short in Hardy and easy to skim, but its counter-examples (§158) explain why later theorems assume continuous partial derivatives. Use the interactive slices to see them fail.
- Stage 4 is where the integral finally gets a definition. If you skipped the existence of the area in Chapter VI as “obvious”, this is where the debt is paid.
- The Miscellaneous Examples at the end of the chapter are long. Try a few on Taylor expansions after stage 2 and a few on integrals after stage 4.
Lessons
18 pages · about 720 minutes of reading, plus time with the book.
- §§150–151 Taylor's theorem: the higher mean value theorems ✓ done How well derivatives at one point predict a function nearby, with the error given exactly (Lagrange) or as .
- §152 Taylor's series ✓ done When the Taylor polynomials of a function converge to it, why this holds for sine and cosine everywhere, and why infinitely many derivatives are not enough.
- §153 Maxima and minima: the first non-vanishing derivative ✓ done When , Taylor's theorem still decides between maximum, minimum and neither.
- §154 Limits of the form 0/0 ✓ done Two methods for limits such as , by comparing expansions and by the ratio of derivatives, and when each one applies.
- §155 The contact of plane curves ✓ done How closely two curves touch, measured by how many derivatives agree, with inflexions and the circle of curvature as the main examples.
- §§156–158 Partial derivatives and the chain rule ✓ done Differentiating a function of two variables one variable at a time, differentiating it along a curve, and why the chain rule needs continuous partial derivatives.
- §159 The mean value theorem in two variables ✓ done The increment of is up to an error small compared with the step, and what it means for such a function to be differentiable.
- §160 Differentials ✓ done How the symbols , , get an exact meaning, why the formula holds whether or not and are independent, and how that is used.
- §§161–162 Definite integrals and areas ✓ done Upper and lower sums squeeze a single number between them when is continuous; that number is the area under the graph, and the definite integral.
- §163 The measure of an angle and the circular functions ✓ done An angle is measured by twice the area of the sector it cuts from the unit circle, and this turns into the integral .
- §164 The integral as the limit of a sum ✓ done Computing integrals straight from the definition, with equal and with unequal pieces, and reading limits of sums as integrals.
- §165 General properties of the definite integral ✓ done The rules for combining integrals, the inequalities between them, the mean value theorems for integrals, and the fundamental theorem of the calculus, all proved from the definition.
- §166 Integration by parts and by substitution ✓ done The two great transformation rules for definite integrals, why substitution works strip by strip, and how they evaluate integrals whose antiderivatives we never find.
- §167 Taylor's theorem by integration by parts ✓ done Integrating by parts gives the remainder in Taylor's theorem as an exact integral, from which Lagrange's and Cauchy's forms both follow by the mean value theorems for integrals.
- §168 The binomial series by Cauchy's remainder ✓ done Cauchy's form of the remainder finishes the proof that for every between and , exactly where Lagrange's form gave up.
- §169 Approximate integration: Simpson's rule ✓ done The trapezium rule and Simpson's rule, their error formulae, and why Simpson's rule, exact for cubics, wins the race by a factor that grows with the work done.
- §170 Integrals of complex functions of a real variable ✓ done Integrating part by part, the inequality seen as "a straight line is the shortest path", and which real theorems survive.
- Problems Chapter VII problems ✓ done Eleven of the Miscellaneous Examples on Chapter VII, on Taylor expansions, functions of several variables and definite integrals, with graded hints and full solutions.